Meriam M2 – Series Smart Manometer - Manual (Page 20)

14
Header Name
Follow the steps below to edit the Header Name.
Keystroke Display
1. From the Measure
Mode press the PRGM
key.
Top line reads “PROGRAM
MODE” and bottom line
reads “UNITS SELECT”.
2. Press the up arrow
key twice. Bottom line changes to
“USER INFO SELECT”.
3. Press the PRGM key. Bottom line shows serial
number.
4. Press the up arrow
key six times.
Top line reads “HEADER
NAME” and bottom line
reads “MERIAM”. The
cursor flashes at bottom
left.
5. If header is correct
press backspace key. If
editing is desired
proceed to step 7.
Top line reads “PROGRAM
MODE” and bottom line
reads “USER INFO
SELECT”.
6. Press the left arrow
key. Returns to Measure Mode.
7. Press the up or down
arrow keys to set the
correct alpha-numeric
value. Displays a number between
0 and 9, a letter from A to
Z, / or a blank space.
8. Press the right arrow
key to accept entry. Cursor advances one
space to right.
9. Repeat steps 8 and 9
until the desired Header
is shown.
10. If an error is made
press the back arrow
key until the cursor is
over the incorrect value.
Follow step 8 to correct.
Press the right arrow
key to advance the
cursor without changing
values.
11. When the Header is
complete press the
PRGM key until header
accepted.
Top line reads “PROGRAM
MODE” and bottom line
reads “UNITS SELECT”.
12. Press the left arrow
key. Returns to Measure Mode.