Micromod Micro-DCI: 53SL6000 Single Loop Controller - Manual (Page 16)

Thermal Shock ± 66 ° C/hr ( ± 150.8 ° F /hr)
(storage/transport)
Physical Shock 15 g 1/2 sine, 11 ms
(operation)
Physical Shock ASTM D4169, DC1
(storage/transmit)
Vibration - 0.76 mm, 5 to 14 Hz
point-to-point 0.3 g, 14 to 200 Hz
constant
displacement
(operation)
Vibration ASTM D999
(storage/transport) B 3-100 Hz
0.5 g
Corrosion ISA S71.04, airborne contami-
nates G3 for 10 years.
ESD IEC 801-2 8.0 kV
Transient Immunity IEC 801-4,
power 4 kV direct,
signal 2 kV capacitively coupled
EM Emission CISPR Pub. 11 Class A
EMI Susceptibility SAMA PMC 33.1 - 1978
Class 3 - abc: no effect at 30 V/m,
at 27, 146, and 446 MHz;
IEC 801-3 10 V/m
Surge Withstand ANSI C37.90a - 1974/IEEE
Capability Standard 472 - 1974
Ring Wave: 1.5 MHz, 3 kV,
60 pulses/second for 2.0 seconds
AC Power
Voltage Range 93.5 to 276 V ac
Frequency Range 47 to 63 Hz
Power Consumption 8 W/14 VA
(no options
Installed,
transmitter supply
not in use)
Power Consumption 20 W/36 VA
(options installed
transmitter supply
in use)
Permitted Voltage ≤ 20 ms
Dips
DC Power
Voltage Range 20 to 30 V dc
Power Consumption 8 W
(no options
installed
transmitter supply
not in use)
Power Consumption 15 W
(options installed
transmitter supply
in use)
Permitted Voltage ≤ 20 ms
Dips
Transmitter Supply
(referenced to power common)
Voltage Range 24 V to 26 V
Ripple ≤ 200 mVp-p
On-Load Current ≤ 50 mA (short circuit protected)
Pulsing Short 50 mA
Circuit Current
Analog Inputs 1 and 2
(referenced to power common)
Number 2, non-isolated
Rated Signal Range 0/4 to 20 mA
(for each input)
Control Range 0 to 21.5 mA
Input Impedance 250 ohm
Filter Time Constant 50 ms
Measurement Error ≤ ± 0.02 mA
Temperature Effects ≤ ± 0.002 mA/ ° C
Discrete Inputs 1 and 2
(referenced to power common)
Number 2 (dry contacts or power contacts
up to 24 V dc)
Signal Low 0 to 1 V dc
Voltage
Signal High 4 to 24 V dc
Voltage
Input Impedance 1000 ohm
Signal Low Contact ≤ 100 ohms
(closed)
Signal High Contact ≥ 5000 ohms
(open)
53SL6000 Instruction Manual Section 1. Introduction
1-4