Micromod Micro-DCI: 53SL6000 Single Loop Controller - Manual (Page 33)

Figure 3-5. Editing a Parameter
NOTE 1: There is a 12.5 second time-out that
occurs if a parameter prompt is not selected in
engineer mode.
NOTE 2: oPEr and conF parameter changes take
affect immediately. If a ProG menu parameter is
edited, the controller goes to the offline condition
in which no control action is performed.
3.5.2.2 Deselecting and Scrolling
Backward
Figure 3-6 illustrates how to move through the vari-
ous modules and their parameters by using the
deselect and scroll backward push buttons. Figure
3-6 begins with the last level 4 edit select step in
Figure 3-5 where the bASE parameter of the Ai.2
module was updated. The object in Figure 3-6 is to
exit the Ai.2 module after the bASE parameter has
been updated and to access the Ai.1 module where
any one of its parameters can be scrolled and se-
lected for updating.
3.5.2.3 Editing a Numeric Value
If a parameter value must be entered in the red dro,
different editing steps must be performed than
when a selection is made from an item list. Figure
3-7 illustrates these steps; it assumes engineer
mode has been entered, and the menu, module,
and parameter have been selected. The parameter
conF-Ai.1-SPAn will be edited from 100.0 to 275.0.
Only the red dro showing the conF-Ai.1-SPAn
value appears in the illustration.
Figure 3-8 illustrates changing the conF-Ai.1-SPAn
value from 100.0 to 10.00 by moving the decimal
point. It assumes engineer mode has been en-
tered, and the menu, module, and parameter have
been selected.
53SL6000 Instruction Manual Section 3. Display Panel
3-6