Micromod Micro-DCI: 53SL6000 Single Loop Controller - Manual (Page 34)

Figure 3-6. Deselecting and Scrolling
Backward
Figure 3-7. Editing a Red dro Value
Figure 3-8. Moving the Red dro Decimal
Point
3.5.2.4 Editing the Tag Parameter
The tAG is one parameter where an alphanumeric,
rather than a numeric, can be entered. It occurs
when the datalink controller conF-SYS-tAG pa-
rameter must be configured. Because four charac-
ters maximum can be displayed at any one time in
the red dro, using the shift right push button in
engineer mode allows the ten character positions
to be displayed as follows:
0123 → 3456 → 6789
The bold characters are those that can be changed
with each four position display.
Characters are selected for each position with the
scroll forward/backward push buttons in a manner
described in Figure 3-7. The procedure to edit the
tag is described in Figure 3-9. It assumes the
conF-SYS-tAG parameter is already accessed.
Section 3. Display Panel 53SL6000 Instruction Manual
3-7