ATON AH66T - Manual (Page 41)

A T O N AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 40
ELAN ® C2 Communication Controller Integration
The ELAN C2 Communication Controller integrates paging, telephone and home
automation features with the AH66T. The C2 provides Music On Hold, Paging, Door Chime
and Relay Activation features.
The audio from the INTERNAL TUNER of the AH66T is routed out of the MOH OUT port and
into the C2. The C2 sends a Trigger signal when a Page or Door Chime is initiated that
causes the AH66T to mute any audio that is playing and pass the Page or Door Chime
audio to the AH66T’s zones at a preset level. The C2’s Relays are controlled by touchtone
telephones.
Make all C2 connections to phone lines, door stations and relay controlled devices as
shown in the C2 manual.
Connect the MUSIC ON HOLD OUTPUT of the AH66T (MAIN chassis only) to the MUSIC
ON HOLD INPUT of the C2. Connect the PG/DB AUDIO OUTPUT of the C2 to the PG/DB
INPUT of the AH66T.
If two AH66Ts are being integrated, use an RCA “Y” cable from the PG/DB AUDIO OUTPUT
of the C2 to the AH66T’s PG/DB AUDIO INPUT.
Connect the A-Net OUT from AH66T chassis # 1 to the A-Net IN of AH66T chassis # 2.
Connect the A-Net OUT of AH66T chassis # 2 to the VIANet IN of the C2.
Figure 4-7: C2 Connections