Electronics International MVP-50T - Manual (Page 12)

If any function on the Main or System Screen goes into the red or
yellow, the appropriate annunciator will blink, the external warning
light will blink and an appropriate voice warning will be played. In
this way the pilot is immediately alerted of a potential problem and
should view the appropriate screen for further information.
Setup and Control Screen Menu (see section 5.0): The Setup
and Control Screen Menu provides access to screens containing
parameters that the pilot may want to change from time to time during
a flight (brightness control, screen button setup, etc.).
System Configuration Screens (see section 6.0): The System
Configuration Screen Menu provides a list of screens used to
configure the MVP for almost any aircraft. These screens allow the
installer to view the setup functions, screens, instrument markings,
limitations, weight and balance setup, flap and trim calibration, fuel
tank calibration and other system setup requirements. The “MVP-
50T Setup Checklist” will guide the installer through the necessary
steps to set up the MVP for a specific aircraft. The “MVP-50T
Setup Checklist” is provided on a separate blue tag-board To make
a change to data on any one of these screens requires the
appropriate password (see the Password Protection section of this
manual).
All of the System Configuration Screens will be displayed with a
black background and the annunciators and engine instruments will
not be displayed.
1.3 System Hardware:
5
Setup and Control Screen Menu
System Configuration Screens
Master
Warning
Light
To
Pwr & Gnd
GPS
Auto Panel
Warning
and
Caution
Lights