Figure 2, Figure 1 – King Kooker Cast Cookers with Timers User Manual
Page 12
12
Figure 2
Hose WItH FemAle FIttInG And AdjustAble reGulAtor And tImer.
Figure 1
Hose WItH mAle FIttInG And AdjustAble reGulAtor And tImer.
4. NOTE: The hose to burner connection will be one of the following:
Figure 1) Hose with male fitting and adjustable regulator.
Figure 2) Hose with female fitting and adjustable regulator.
Refer to the appropriate diagram below for hose connection instructions:
Tighten the hose fitting into the venturi with a torque wrench, up to a torque of 95 to 105 lb./in.
Alternatively, hand tighten securely and then, using a wrench, tighten an additional 1-1 1/2 turns.
5.
Go to the
use and care section for further instructions.
note:
If your cooker has attachable legs or work table, or requires additional construction, follow
the assembly instructions for these before proceding to the use and care section.
The air shutter and half union as pictured should already be assembled to the casting. Check that
fitting is tightened to the venturi tube and that the elbow points downward. Tighten the hose fitting
onto the half union with a torque wrench, up to a torque of 95 to 105 lb./in. Alternatively, hand
tighten securely and then, using a wrench, tighten an additional 1-1 1/2 turns.
20 lb. LP
Gas Cylinder
20 lb. LP
Gas Cylinder
HAlF unIon
WItH orIFIce
WItH orIFIce