Archive, Mgs multi-gun source - safety – Ransburg MGS Multi-Gun Source 76789, 77046 User Manual

Page 7

Advertising
background image

CP-99-01

AREA

AREA

AREA

AREA

AREA

Tells where

hazards may occur.

HAZARD

HAZARD

HAZARD

HAZARD

HAZARD

Tells what the hazard is.

SAFEGUARDS

SAFEGUARDS

SAFEGUARDS

SAFEGUARDS

SAFEGUARDS

Tells how to avoid the hazard.

MGS Multi-Gun Source - Safety

Improper operation or mainte-
nance may create a hazard.

Read all instructions and safety precautions prior
to operating the MGS control unit.

Always turn power to the MGS control unit OFF,
unplug the electrical cord from its outlet, and
remove the front panel fuse, before opening the
MGS control unit cabinet door.

Comply with appropriate local, state, and national
codes governing ventilation, fire prevention, op-
eration, maintenance and housekeeping of this
equipment. Refer to OSHA standard1910, NFPA-
33, 1995 edition and your insurance company re-
quirements.

Operators must be given training in accordance
with the requirements of NFPA 33, Chapter 15.

The following notes apply to the MGS 2000C

The following notes apply to the MGS 2000C

The following notes apply to the MGS 2000C

The following notes apply to the MGS 2000C

The following notes apply to the MGS 2000C
only:

only:

only:

only:

only:

Whenever removing high voltage cables from
equipment, ground the contact end of the cable
by holding the cable such that the contact
touches earth ground for several seconds. Do
not touch the contact until it has been grounded.
This will reduce the possibility of residual charge
causing electrical shock.

The High Voltage Multiplier assembly contains
energy storage components that can cause seri-
ous shock injury, and therefore is not field repair-
able. Warranty will be voided if the High Voltage
Multiplier seal is broken. If the High Voltage Mul-
tiplier is defective contact your authorized ITW
Ransburg representative for exchange or repair.

The High Voltage Multiplier and high voltage
cable contain significant capacitance that will
store charge. Allow approximately 10 seconds
for this charge to bleed off before removing the
high voltage cable from the power supply or
spraygun.

General Use and

General Use and

General Use and

General Use and

General Use and
Maintenance

Maintenance

Maintenance

Maintenance

Maintenance

3

3

3

3

3

ARCHIVE

Advertising