Robertshaw 9700 - Manual (Page 15)

15
PROGRAMMING
4. Press SET button. The display will show the setpoint temperature
NOTE: Pressing QUICKSET button instead of the SET button will
also save your program settings.
5. Press either ∨ or ∧ button to adjust the setpoint temperature
for the programmed MORN time. (NOTE: Holding down either
∨ or ∧ button scrolls the temperature in 1˚ increments.)
6. Press SET button. The display will show AUTO with FAN.
7. Press either ∨ or ∧ button to program the fan to be in AUTO
(fan cycles with system when required for heating or cooling)
or ON (fan remains on continuously) for the individual daily
setpoint your are programming.
8. Press SET button.
9. Repeat steps 3-8 for the remaining DAY, EVE, and NIGHT
settings.
MON TUE WED THU FRI SAT SUN
MORN
AUTO FAN
MON TUE WED THU FRI SAT SUN
MORN
FAN ON
F
MORN
MON TUE WED THU FRI SAT SUN
SET
SET
SET
5. Press SET button to save second digit. The third digit will flash.
6. Press ∨ or ∧ button to enter the third (right) digit.
7. Press SET button to save third digit. "Lock” appears on the
screen and your combination is now saved.
Unlocking keypad:
1. Press LOCK button. The display will show “000.”
2. Follow steps 2-7 as listed above in “Setting your combination and
lock keypad.” If combination is correct, the word “LOCK” will
disappear from the display and the program may be changed. If
combination is not correct, the thermostat will display the word
“no” and return to normal display mode.
If, for any reason, you have forgotten your combination or are
unable to unlock the keypad, press reset button on the rear of the
thermostat. See “REMOVING THERMOSTAT FROM SUBBASE”
and “Resetting the Thermostat.” Pressing reset will erase ALL
programmed information as well as time clock and day of week.
22 PROGRAMMING
RESET
SET
SET
LOCK
MON
LOCK
HEAT
AUTO FAN
F
AM
PM
MANUAL