Robertshaw 9700 - Manual (Page 4)

The Maple Chase Item 9700 is directly compatible with 24V AC single stage heating and cooling systems.
It will operate with all standard forced air gas, oil, and electric heating and air conditioning systems as well
as hot water heating systems and single stage heat pump systems that do not have auxiliary or emergency
heating. No optional items are required.
This thermostat will automatically control the heating and/or cooling system. Once programmed, it will
automatically adjust the temperature setting and fan operation at your programmed times. When used
properly, this thermostat can reduce heating and cooling costs throughout the year.
TABLE OF CONTENTS
Product Features ..................................2
KeyPad Quick Reference ......................3
Important Safety Information ..............5
Helpful Programming Tips....................6
NiteView™ LCD Display Backlight ......7
Removing Thermostat from Wiring
Subbase ................................................8
Programming ........................................10
Set or Change Time, Day, etc ........10
Selecting ˚F/˚C ................................11
Programming with Quickset..........14
Review, Change, or Personalize ....16
Review or Modify Program ..........19
Programming Filter Monitor ........20
4
Checking Filter Monitor ................20
Resetting Filter Monitor ................20
Programming Keypad Lock ..........21
Unlocking Keypad ..........................22
Operation ..............................................23
Beginning Programmed
Operation. ......................................23
Resetting Thermostat ....................24
Selecting Auto Changeover ..........25
Changing Dip Switch Settings..............27
Replacing the Batteries ........................28
Cleaning ................................................30
Troubleshooting ....................................31
Warranty ................................................35
33
Symptom Remedy
System runs too long. Temperature differential may be set too high. Decrease temperature
differential to lower setting, see "PROGRAMMING".
System will not enter AUTO Thermostat must be in PROGRAM mode to run AUTO system operation.
(Auto Changeover) mode. Press PROG/MAN button until PROGRAM is indicated in display. Then,
press SYSTEM button until AUTO is indicated in display.
Room temperature reading is If you have attached remote sensors, the thermostat will display the
inaccurate. average temperature of the activated sensors. See "INSTALLATION
INSTRUCTIONS" and "CHANGING DIP SWITCH SETTINGS".
If there are no remote sensors attached, make sure that the remote sensor
dip switch settings on the rear of the thermostat body are turned off and
the MAIN thermostat dip switch is turned on. See "CHANGING DIP
SWITCH SETTINGS."
Thermostat will not let me change AUTO (changeover) mode may be active. See OPERATION - Selecting
setpoint temperature above or below Auto Changeover. AUTO will be indicated in display.
a certain point.
Thermostat turns on system before my Early recovery mode is in effect. This optional feature turns on the system
programmed setpoint time. prior to the next setpoint time to reach the temperature you have
programmed. See "PROGRAMMING". If you wish to change your
thermostat to normal recovery, see 'CHANGING DIP SWITCH SETTINGS".