Robertshaw 9700 - Manual (Page 21)

16 PROGRAMMING
10.Press SYSTEM button for opposite program (HEAT or COOL).
11.Repeat the above steps to enter the temperature settings for the
opposite season.
NOTE: When programming opposite season, remember that both
programs use the same time settings and programmable fan settings.
Review, Change, or Personalize Program
NOTE: The thermostat will not allow programs to be entered in the
OFF or AUTO modes.
1. Press the SYSTEM button until the word "HEAT" or "COOL"
appears on the right side of the display.
SYSTEM
SYSTEM
MON
HEAT
M A N U A L AUTO FAN
F
PM
MON
COOL
M A N U A L AUTO FAN
F
PM
Setting your combination and lock keypad:
1. Press SET and LOCK buttons at the same time. Release both
buttons. The display will show "000." The first digit will flash.
2. Press ∨ or ∧ button to enter the first (left) digit.
3. Press SET button to save first digit. The second digit will flash.
4. Press ∨ or ∧ button to enter the second (middle) digit.
21
PROGRAMMING
Programming Keypad Lock
NOTE: In order for the lock function to work as described below, the "LOCK" function must have been enabled during
installation. If the Lock function does not seem to work, you must change a dip switch located on the back of the
thermostat. See “CHANGING DIP SWITCH SETTINGS” section to turn the “LOCK” function on.
This thermostat has a keypad lock that will prevent unauthorized program changes. When the keypad is locked, the
user must enter the 3-digit combination or the keypad will not allow programming changes.
IMPORTANT: Please write down your chosen 3-digit combination in a convenient location away from the thermostat.
The thermostat WILL NOT let you change the settings or the mode if you forget the combination. When the
thermostat "LOCK" function is on, only the LOCK keypad button is functional until the thermostat is unlocked.
SET
LOCK
SET