Robertshaw 9700 - Manual (Page 23)

14 PROGRAMMING
Programming with QuickSet™
NOTE: To save valuable programming time, QuickSet™ allows you to set one schedule that is automatically copied
to each individual day of the week. You may then go into the program and change any specific day, time setting, or
temperature setting to suit your personalized schedule.
NOTE: The thermostat will not allow programs to be entered in the OFF or AUTO modes. Program in HEAT or COOL
modes only.
1. Press the SYSTEM button until the word “HEAT”or “COOL”
appears on the right side of the display.
2. Press QUICKSET button.The display will show all the days of the
week at the top of the display. This signals that you are in
QuickSet™ mode. "MORN” is the first setting for the day. The
display will show the setpoint time.
3. Press either ∨ or ∧ button to adjust the time setting for MORN. (Note:
Holding down either ∨ or ∧ button scrolls the time in 30 minute
increments.)
MON TUE WED THU FRI SAT SUN
MORN
AM
MON
HEAT
M A N U A L AUTO FAN
F
PM
MON
COOL
M A N U A L AUTO FAN
F
PM
SYSTEM
QUICKSET
OPERATION
The thermostat is now ready to run your saved programs and automatically control the temperature at your programmed
time settings. The thermostat will “flash” the word “heat” or “cool” in the main display when the system is active.
23
MON
P R O G R A M AUTO FAN
F
PM
AUTO
MON
P R O G R A M AUTO FAN
PM
F
OPERATION
Beginning Programmed Operation:
NOTE: DO NOT switch system to COOL if outside temperature is
below 50˚F. This can damage the compressor/condenser unit on
your system.
1. Press PROG/MAN button until the display shows that the
thermostat is in the PROGRAM mode. This will allow you to
begin programmed operation.
2. Press SYSTEM button until HEAT, COOL, or AUTO appears on
the display (depending on the season). COOL will control the
air conditioner. HEAT will control the heating system. AUTO
will automatically choose between the HEAT or COOL
programs, depending on the temperature. (See “SELECTING
AUTO CHANGEOVER” for more information.) OFF will show in
the time field when the thermostat is off and not
operating the system. Depending on whether the fan
is programmed or manually set to AUTO or ON, the
fan will automatically run (with or without a delay)
along with your program. SYSTEM
PROG/MAN
MON
HEAT
AUTO FAN
F
PM
P R O G R A M
MON
COOL
AUTO FAN
F
PM
P R O G R A M