Robertshaw 9700 - Manual (Page 28)

To replace thermostat onto wiring subbase (cont.):
3. Press SYSTEM button to put the thermostat into HEAT,
COOL, or AUTO mode. The thermostat will return to normal
operating mode.
You may reset the thermostat at any time. Reset is located on the
back side of thermostat in the lower, right corner. See diagram.
Pressing reset will erase ALL programmed information as well as
time clock and day of week.
9
RESET
SYSTEM
28 OPERATION
Changing dip switch settings:
1. Use a small screwdriver or pencil to move the switch to the
desired setting.
2. Press RESET button. See Figure 5. Pressing RESET will erase
any previously entered programming information.
IMPORTANT: New dip switch settings for Dip Switch #2 will not
register or operate options until the RESET button is pressed.
REPLACING THE BATTERIES
This thermostat has two levels of low battery indication. As the
batteries weaken, the thermostat will go to the next stage of low
battery indication.
Low Battery—Stage 1
“LO BATT” stays constant on the display. Replace batteries soon.
Display and thermostat functions normal.
Low Battery—Stage 2
“LO BATT” stays constant on the display and thermostat “beeps”
about once a minute. Replace batteries immediately. Display and
thermostat functions normal.
NOTE: When changing the settings on “SWITCH 1”, the reset
button does not have to be pressed for the new configuration to
register or operate.
RESET
- + - +
- + - +
TCH 1
Figure 5
MON
M A N U A L
HEAT
PM
LO
BATT
F