Robertshaw 9700 - Manual (Page 18)

19
7. Press SET button. The display will show AUTO with FAN.
8. Press either ∨ or ∧ button to adjust the fan setting to be in AUTO
(fan controlled by system when required for heating or cooling)
or ON (fan remains on continuously) for the individual daily
setpoint you are programming.
9. Press SET button.
10. Repeat steps 3-9 for the remaining DAY, EVE, and NIGHT settings.
11. Press SYSTEM button for opposite program (HEAT or COOL).
12. Press SET button and repeat above steps for opposite program.
NOTE: Program changes made to setpoint times, temperatures, or
fan operation are not saved in memory unless you finish the operation
by pressing the SET button after each entry as shown above.
NOTE: When programming opposite season, remember that both
programs use the same time and programmable fan settings.
18
MON
MORN
FAN ON
PROGRAMMING
MON
MORN
AUTO FAN
MON
MORN
FAN ON
SET
SET
SYSTEM
SET
Review or Modify Program
1. Press SYSTEM button until the word "HEAT" or "COOL" appears on
the right side of the display. This will choose the program you wish to
review or modify.
2. Press SET button.
3. To advance through each day's programmed setpoint times,
temperatures, and fan settings continue to press the SET button.
Each time you press the SET button, the LCD display will
advance to the next setting in the program.
4. Press ∨ or ∧ button to change any individual day's setpoint times,
temperatures, or fan settings.
5. Press SET button to save any changes and continue reviewing
your program.
6. Repeat 1-5 to review or modify the opposite program.
PROGRAMMING
SYSTEM
SET
SET
SET
MON
HEAT
M A N U A L AUTO FAN
F
PM
MON
COOL
M A N U A L AUTO FAN
F
PM