SKC Limited Haz-Dust IV - Manual (Page 22)

Setting the Date and Time
Introduction The date and time are pre-set by the factory to Eastern Standard Time and are
maintained by an internal clock. It may be necessary to change the date and
time due to local time zones or daylight savings time.
Note: It is important that the system date and time are correct for accurate
record keeping.
Date and Time
settings Time is entered and displayed in military time format.
Date is entered and displayed in European format (i.e., MON. 17-DEC-04).
View settings Follow the steps in the table below to check the units date and time.
Step Action
1 Select Special Functions from the Main Menu.
2 Select Date/Time.
3 Select View Date/Time.
Result: The unit’s current date and time will display.
4 Press ENTER to return to the Date/Time Screen.
Change settings Follow the steps in the table below to change the units date and time.
Step Action
1 Select Special Functions from the Main Menu.
2 Select Date/Time.
3 Select Set Date/Time.
4 Enter the correct date and time using the steps in the table below.
To... Press...
Increase the value of the selected digit. < ↑ >
Decrease the value of the selected digit. < ↓ >
Select the next digit or field. ENTER
5 Press ENTER when the correct information has entered.
To... Select...
Update the selected date and time. Set Date/Time
Return to the Date/Time screen without
saving changes.
Cancel
2 - 5