SKC Limited Haz-Dust IV - Manual (Page 48)

Downloading Data
Introduction Internally stored data can be downloaded to DustComm for detailed analysis.
Downloading
data The three major steps used to download data from the EDC dust-monitoring
unit to a PC are listed below and detailed in the next few pages.
1. Connect the cable.
2. Prepare the PC for data transmission.
3. Prepare the EDC dust-monitoring unit for data transmission.
Connect the
cable Follow the steps in the table below to connect the cable for data transmission.
Step Action
1 Connect one end of the supplied RS232 cable to the EDC dust-
monitoring unit.
Note: If USB compatibility needed you will need to purchase a
serial to USB adapter.
2 Connect the other end of the RS232 cable to the appropriate
COMM port on the PC.
Note: Check that both connections are secure. An intermittent
connection can disrupt data transmission.
Preparing the
PC Follow the steps in the table below to prepare the PC for data transmission.
Note: Multiple locations will be separated by tabs at the bottom of the
program.
Step Action
1 Open DustComm.
2 Select Unit and Select Properties.
3 Under the Properties selection choose your unit and the Com Port
that you want to connect. Press Ok when you are finished
4 Select Unit and Select Download.
5 When the items above are finished you should see the download
box appear.
Continued on next page
4- 8