SKC Limited Haz-Dust IV - Manual (Page 38)

Location Codes
Introduction The Haz-Dust IV assigns a location code to each sampling sequence. The
active location is indicated in the Data Record Screen (figure 3.10).
Maximum
location codes The Haz-Dust III can store a total of 21,500 data points, which can be
distributed into a maximum of 999 locations.
Assigning
location codes The location code assigned to the site is determined by the memory storage
type selected in step number three of the sampling process (page 3-10).
Use the table below to identify the location code being used.
Data storage type selected... The Haz-Dust IIV Assigns...
Continuation The Next Consecutive Value as the
Location Code.
Example: If data was previously stored
in locations #001 and #002 the data being
collected will be stored in location #003.
Overwrite 001 as the Location Code and all
previously stored data points in all
locations are erased.
3 - 14