Turning the epam-7500 on and off – SKC Limited EPAM-7500 User Manual
Page 20
2-2
Turning the EPAM-7500 On and Off
Introduction
Power can be supplied to the EPAM-7500 either from its internal battery or
from the provided AC power transformer (Battery Charger).
Note: T
HE BATTERY SHOULD BE FULLY CHARGED
before each use. To
charge battery use the EDC supplied charger only. LED indicator on the
EPAM-7500 will turn green when the battery is fully charged. Charge time is
approximately 22 hours and will run for approximately 24 hours. To check
battery status see Page 5-8.
Power-On
Plug battery pack into EPAM-7500. When power is connected to the EPAM-
7500, the instrument will turn itself on. There will be a blinking green LED
on the front of the instrument when the EPAM-7500 begins to boot up.
If the EPAM-7500 does not turn on, press the green I/O power button on the
front of the EPAM-7500.
Power-Off
Result: Press the green I/O power button on the front of the EPAM-7500 to
turn the EPAM-7500 off. Also, pressing the red I/O graphic on the display
can turn the EPAM-7500 off or go to standby mode.