SKC Limited EPAM-7500 - Manual (Page 28)

3-3
EPAM-7500 Impactor Instructions
Impactor Part Number: EPAM-1.0, EPAM-2.5, EPAM-4.0, and EPAM-10
Impactor Sleeve Part Number: IMS-105
The Impactor consists of the cup and the impactor jet. The Impactor cup fits onto the impactor
jet. The cup has three female connectors and the jet has three pins. User can easily remove for
cleaning without the use of any tools.
STEP 1: The completed assembly of the impactor fits into the impactor sleeve. Insert the cup
end of the impactor first into the impactor sleeve. You will need to insert the impactor
approximately one inch or 25mm down into the impactor sleeve.
Impactor Jet
Sizes 1.0um, 4.0, 2.5um, 10um
Impaction Cup
remove for applying
impactor grease & cleaning
Impactor Sleeve
Impactor Assembly
Push down into sleeve 1
inch (25mm)