SKC Limited EPAM-7500 - Manual (Page 35)

3-10
Sampling
Introduction Once you have selected a Particle Size and completed the EPAM-7500 is
ready to begin sampling.
Note: It is recommended to trial sample in the environment where you will be
air monitoring for 15 minutes to allow EPAM-7500 to stabilize prior to
beginning first sample.
Conditions The following conditions should be met before starting the sampling process.
Condition... For further Information
See Page...
The correct particle size must be selected. 3-2
The correct sampling inlet must be attached. 3-2 to 3-8
The date and time must be checked and/or set. 2-4
The alarm level must be set if sampling with
the alarm feature. 2-5
Sampling Follow the steps in the table below to begin the particle sampling.
Step Action
1 Turn unit on.
2 Select Monitor.
3 Select the Record graphic to start recording.
4 Note: See page 3-13 for explanation of location codes.
5 When in Monitor, select the information graphic to see the
settings of the EPAM-7500.