Sonnet Technologies Encore_ZIF Processor Upgrade - Manual (Page 85)

Remove Processor Card
To unlatch the ZIF socket lever (Figure 5), push the
lever down and then out to clear the side tab. Once
the level is clear of the side tab, rotate the lever up
90˚. Gently lift the existing processor card up and
out of the ZIF socket.
Install Encore/ZIF Processor Upgrade
Card
1. Remove the Encore processor upgrade card
from the anti-static package, making sure to
handle the card by the edges (Figure 6). Gently
peel the pin protection foam off the Encore
card. Transfer the foam to the processor card
you removed from the computer. With the
foam attached, place it into the anti-static
package and store it in a safe place.
2. Notice that one corner of the Encore processor
upgrade card, identified as position 1, does not
have a pin (Figure 7).
3. The ZIF socket has a corner without a hole
(Figure 8). Align and lower the Encore card so
that position 1 on the Encore matches with
the corner of the ZIF socket without the hole.
If you encounter any resistance, raise the
card and check for bent pins; then, realign
the card over the socket and gently lower it
again. Be very careful! Broken pins are not
covered under warranty.
En
4-6
Figure 5; Figura 5
ZIF socket lever
Figure 6; Figura 6
Figure 7; Figura 7
Figure 8; Figura 8
position 1
corner without hole
anti-static
package
processor
card
Encore/ZIF
card
Encore/ZIF
card
ZIF socket
ZIF socket
Encore/ZIF
card