Sonnet Technologies Crescendo_NuBus Processor Upgrade Card - Manual (Page 52)

46
Chapter 4
2. Using a small Phillips screwdriver, remove the three standoffs from
the video adapter board. Locate the two subassembly standoffs
from the video adapter packaging. Assemble and secure one
subassembly standoff to the upper right corner of the board, and
the other subassembly standoff to the lower left corner (Figure 12).
3. Align the HPV card directly over the video adapter board with the
connector of the HPV card facing upwards (Figure 13). The holes
on the HPV card should align directly with the standoffs on the
adapter board. Secure the HPV card to the video adapter board with
the two nuts (Figure 13) supplied with the adapter kit.
4. Continue with the instructions in the section entitled, “Install
Video Flex Cable Onto Crescendo Card” on page 48.
Figure 12: Assemble and secure subassembly standoffs as shown
Figure 13: Secure HPV card to video adapter board with nuts
HPV card connector facing upwards
subassembly
standoff
subassembly
standoff