Sonnet Technologies Crescendo_NuBus Processor Upgrade Card - Manual (Page 55)

49
Power Macintosh 8100, 8115, and Workgroup Server 8150 Installation
Install Crescendo Card Into PDS Slot
Align the Crescendo card over the PDS slot on the logic board with the
card’s heatsink facing toward the power supply (Figure 19). Gently press
down until the card is firmly seated in the PDS slot.
Remove Access Port Cover From Middle NuBus Port
1. Remove the access port cover (if installed) from the middle NuBus
port located at the back of the computer (Figure 20). Use your
finger or a small flatblade screwdriver to push it out from the port
(Figure 20).
Figure 19: Install Crescendo into PDS slot
PDS slot
Crescendo card
(with attached video flex cable)
Figure 20: Push out middle NuBus access port cover with screwdriver