IAI America RCA2-TW4N User Manual
Page 111
Advertising
103
13. Maintenance and Inspection
(2) To grease ball screws, first clean, then put some grease on your finger and apply while moving the
table back and forth.
When finished, wipe off excess grease.
For the table type, put the ball screw cover back on.
Caution: When moving the slider or table back and forth by hand, be certain never to apply force in
excess of the thrust direction external force capacity (refer to 11.1.2). (If the slider will not
move, operate it using a jog function.)
In case the grease got into your eye, immediately go to see the doctor to get an
appropriate care.
After finishing the grease supply work, wash your hands carefully with water and soap
to rinse the grease off.
•
•
Advertising