IAI America RCA2-TW4N - Manual (Page 118)

110
13. Maintenance and Inspection
[7] Align the marking on the motor shaft with the point indicated and insert the replacement motor unit
into the actuator.
[8] Take out the motor unit and the dedicated replacement jig (large). (Do not allow the jig (large) to
turn.)
[9] In order to keep the jig (large) from turning, draw a mark using a pen or marker.
[10] Insert the dedicated replacement jig (small) in such a way that its protrusion is aligned with the
groove in the motor shaft.
Motor shaft
Alignment mark
Top view
Dedicated replacement
jig (small)