IAI America RCA2-TW4N User Manual
Page 84
76
9. Installation
9.3.2
Short types
[1] TCA3NA, TCA3N (Slide screw, Ball screw), TCA4NA, TCA4N (Slide screw, Ball screw)
Please attach the load to the device using the tapped holes in the front plate of the table type.
There are also tapped holes and reamed holes in the top surface of the table. Please use these to attach
the load.
There is one reamed hole on the slider in the top surface of the table, so if you need to be able to secure
and detach the load multiple times, please use this hole. Also, if you require precision in your attachment,
such as a right angle, use one reamed hole to make fine adjustments.
The process for attaching these to the main unit is similar to the installation process of the main unit. The
mounting screws and tightening torque required are also similar to the installation process of the main unit.
(Refer to 9.1.2.)
Mount a work part by holding the table as shown in the figure. If you hold only the main body and tighten
the work part, excessive moment is applied to the guide area and play may be generated.
Pay attention to the thread length, because the threaded holes on the front table are through holes.
(TCA3NA, TCA3N (Slide screw, Ball screw))
(TCA4NA, TCA4N (Slide screw, Ball screw))
e
t
a
l
p
t
n
o
r
F
e
t
a
l
p
t
n
o
r
F
4-M4, through
depth 3
4-M4, through
dept
h
3
dept
h
3
depth 3
Main body
F
F