Introduction – IntelliTrack WMS – Warehouse Management System User Manual
Page 122
I
NTELLI
T
RACK
WMS: W
AREHOUSE
M
ANAGEMENT
S
YSTEM
V
8.1
User Manual
96
Introduction
Once you have set up your system options and lookups, you are ready to
assemble the following warehouse information and enter it into the system.
Note: Before you can effectively enter receiving and picking orders into
the system, it is important to establish site locations, items, initial item
quantities, customer information and vendor information, so that it is
available for selection in the receiving and picking order forms.
•
Site Locations: enter specific warehouse locations. Performed at the
Locations form in the WMS application. For more information, please
refer to
“Creating Locations for Each Site” on page 97
•
Item Data: enter inventory items and descriptive information about the
items. Performed at the Item Data form in the WMS application. For
more information, please refer to
“Adding Items to IntelliTrack WMS” on
.
•
Initial Item Quantities: enter the initial item quantity, so that the sys-
tem will track the amount on hand of the item. Performed at the Inven-
tory Data form. For more information, please refer to
“Editing an Item
Quantity in a Location” on page 141
.
•
Customer Data: add customer identification, billing address, and ship-
ping address. Performed at the Customers form. For more information,
please refer to
“Managing Customer Information” on page 124
.
•
Vendor Data: add vendor identification and address. Performed at the
Vendors form. For more information, please refer to