Inter-M HDRC-Z440 - Manual (Page 14)

The setting procedure is the same as above.
NOTE: 09:AUTO-PAN mode(Endless panning)
3.5 Preset
(Shortcut: PRST)
If you need to view specific places routinely, you should program presets. A preset is a programmed video
scene with automatic pan, tilt, zoom, focus, and AE settings. Once programmed, placing the number
position and pressing a PRST button on your controller calls up that preset automatically. In addition, presets
may be assigned to alarm actions or
as the “home” position for the dome camera. As many as 240 presets, whose positions are saved in the
dome’s firmware, may be programmed.
There are three pages of preset menu. Each page has 80 presets. Pages can be scrolled
by pushing the Joystick to the Left or Right on the first or last No. of Preset.
- : blank preset position
$ : position has the preset
! : Current cursor position
Follow steps below to store the Preset positions:
1. Press the PRST key to enter the preset menu directly. Or press the MENU key to display the main menu
on the monitor. Scroll to preset and push the Joystick to the right.
2. Select the blank preset position to be stored by pushing the Joystick up, down, right,
or left.
3. After selecting a blank position, press and hold CTRL, Use the Joystick to control the direction of the
camera and lens.
4. After aiming the camera (view direction and lens control), release CTRL. The cursor will be on the Title
then twist the Joystick handle or Press Tele or Wide Key to edit the preset title. Follow the procedure of
the auto scan above to edit titles.
5. Select “CAMERA SET” and pushing the Joystick left or right. Then the preset camera setup displays.
AUTO SCAN AREA SETUP
CTRL KEY
NUMBER01
START: ----- -----
END : ----- -----
EXIT
PRESET SETUP
NUMBER : 001 CTRL KEY
TITLE : ---
CAMERA SET
DWELL : --- SEC 1234567890
----------
----------
----------
NEXT PAGE
SAVE AND EXIT