Inter-M HDRC-Z440 - Manual (Page 15)

PRESET CAMERA SETUP
FOCUS : AUTO
MOTION : OFF
MOTION SETUP
AE SETUP
SAVE AND EXIT
Set FOCUS: AUTO, MANUAL, ONE PUSH
Set MOTION: OFF, ON
Select “MOTION SETUP” and pushing the Joystick left or right. Then the MOTION setup displays.
MOTION SETUP
SENSITIVITY : 12
POSITION : ALL
DELAY : 00 SEC
OUTPUT : OFF
HOLD TIME : 03 SEC
EXIT
Set SENSITIVITY: 1~15
Set POSITION: ALL, CENTER
Set DELAY: 0~5 SEC
Set OUTPUT: OFF, OUT1, OUT2
Set HOLD TIME: 3~99 SEC
Select “AE SETUP” and pushing the Joystick left or right. Then the AE setup displays. Refer to the AE
SETUP in the camera setup.
6. Set “DWELL TIME”(03-99second)
7. To select the next page of presets, scroll the page by pushing the Joystick to the Left
on the first and last columns of the menu.
8. Repeat steps 2 through 7 for each additional preset position.
9. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the Preset menu without saving.
NOTE: Press the HOME key at programmed preset position($) to delete a programmed preset view.
The position, which is marked with $, already has the preset view assigned. To review the stored preset,
press PRST key on the $，The camera will show the stored preset scene.
PRESET AREA SETUP
CTRL KEY
NUMBER 001
PAN TILT
000.0 000.0
EXIT
Press SCAN key on the angle field to display with the small OSD. Then the screen will show as below.