Inter-M HDRC-Z440 - Manual (Page 9)

2.4 Setting Dome Camera Address (ID)
To prevent damage, each HD-SDI Speed dome camera must have a unique address (ID). When installing
multiple HD-SDI Speed dome cameras using a multiplexer, it is suggested that the dome camera address
match the multiplexer port number.
If you want to set the address more than 3999, you should contact the service provider.
Refer to ‘Dome Configuration – DOME ID’ section for detailed information.
2.5 Setting Dome Camera Protocol
If a dome camera is to be installed with a Fastrax keyboard controller,
select the default protocol.
Consult service personnel if a dome camera is installed with device other than a keyboard controller.
Refer to ‘Dome Configuration – DOME ID’ section for detailed information.
2.6 Connections
• Connecting to the RS485
The HD-SDI Speed dome camera can be controlled remotely by an external device or control system,
such as a control keyboard, using RS485 half-duplex serial communications signals. Connect Marked Rx+,
Rx- to Tx+, Tx- of the RS485 control system.
• Connecting Video out connector
Connect the video out (BNC) / HD-SDI out connector to the monitor or video input.
• Connecting Alarms
AL1 to 4 (Alarm In)
You can use external devices to signal the HD-SDI Speed dome camera to react on events. Mechanical or
electrical switches can be wired to the AL (Alarm In) and GND (Ground) connectors..
GND (Ground)
Connect the ground side of the Alarm input and/or alarm output to the GND connector.
Alarm Output 1 to 2
The HD-SDI Speed dome camera can activate external devices such as buzzers or lights. Connect the device
to the Alarm Out and COM (Common) connectors.
• Connecting the Power
Connect the power of 24VAC or 12VDC to the HD-SDI Speed dome camera.
When using a 12VDC adapter, connector the positive(+) pole to the ‘+’ position and
the negative(-) pole to the ‘-‘ position.
Use satisfy clause 2.5 of IEC60950-1/UL60950-1 or Certified/Listed Class 2 power source only.