Inter-M HDRC-Z440 - Manual (Page 17)

Follow the steps below to program the Tours:
1. Press MENU to display the main menu on the monitor. Scroll to Tour and push the Joystick to the right
to enter the Tour menu. Or just press the TOUR key on the keyboard.
2. Select the” NUMBER” and set the desired number by pushing the Joystick left or right.
3. Choose a blank position to be programmed by pushing the Joystick up, down, right,
or left.
4. To add a stored preset, twist the Joystick then the stored preset number displays.
5. To place functions other than preset, press TOUR, PTRN, or SCAN for Tour, Pattern
or Auto Scan respectively.
6. You can also overwrite the programmed number and to remove a stored number from the Tour, press
the HOME key on the stored number, a blank position mark (---) will be displayed.
7. Repeat Step 2 through 5 for each desired position. Each title will be displayed on top
of the line.
8. To edit the title, follow the procedure of the auto scan above to edit titles
9. Select Save and Exit and push the Joystick to the right. Press ESC to exit the program without saving.
You can expand the Tour sequence by calling other programmed tours.
NOTE: The speed applies in the vector mode only.
NOTE: In the Tour mode, in conjunction with preset and Auto Scan, you can make the camera travel from a preset
position to another preset position at a specific speed.
Example: Preset 001>002>003>004>005>006, Auto Scan 01 starts at preset 002, ends at preset 003,
Auto Scan 02 starts at preset 005, ends at preset 006; Tour 001, 002, A01, 004, A02.
1  2 2~3  4  5~6, repeat
where  : Quick move, ~ : Programmed speed
To change the dwell time of the preset in the tour:
Use the Joystick to move the cursor to a stored preset position. By pressing PRST key, the camera will move
to the stored Preset view and the cursor moves to the dwell time field. After changing the dwell time, press
PRST key and the cursor moves to the preset number.
To assign the functions other than preset in the tour when the function key is not existed:
Use the Joystick to move the cursor to a stored preset position. Pressing CTRL key or
IRIS OPEN key will change the preset number to other function (auto scan, pattern, tour, preset) with the first
programmed number. To change the number, twist the joystick or press Tele or Wide key.