Inter-M HDRC-Z440 - Manual (Page 27)

CALIBRATION : ON (Auto origin check) / OFF
MENU TIME OUT : ON(5mintues) / OFF( always menu display)
DOME ANSWER ; ON / OFF(no acknowledge command from the dome) This option is helpful
to escape the collision of the command using some DVR.
PST FOCUS : Set the default mode of the focus when you save the preset
(AUTO / MANUAL / ONE PUSH)
MOTOR SETUP
Motor Setup menu provides the pan and tilt speed of a camera. User can set the desired speed with twist
the Joystick left or right. During operation, pressing 153 + ON will change the speed to the SLOW mode
and pressing 153 + OFF will change the speed to the Normal mode.
Holding and pressing CTRL and moving the joystick will operate with the TURBO speed mode.
PROPOTIONAL P/T : ON / OFF
P/T MODE : SLOW / NORMAL / TURBO
SLOW PAN MAXIMUM : 19˚- 90˚/second
SLOW TILT MAXIMUM : 19˚- 90˚/ second
NORMAL PAN MAXIMUM : 40˚- 360˚/second
NORMAL TILT MAXIMUM : 40˚- 200˚/second
TURBO PAN MAXIMUM : 200˚- 380˚/second
TURBO TILT MAXIMUM : 90˚- 300˚/second
ORIGIN CHECK
When you find the wrong position of the dome during operation, execute this origin check and the dome
camera will arrange the right position after the origin check operation.
Pressing 151 + ON will execute the origin check.
MOTOR SETUP
PROPOTIONAL PT : ON
PT MODE : NORMAL
SLOW PAN MAX : 40°/SEC
SLOW TILT MAX : 40°/SEC
NORMAL PAN MAX : 90°/SEC
NORMAL TILT MAX : 90°/SEC
TURBO PAN MAX : 360°/SEC
TURBO TILT MAX : 100°/SEC
SAVE AND EXIT
ORIGIN CHECK
ARE YOU SURE ?
CANCEL
OK