Inter-M HDRC-Z440 - Manual (Page 24)

ALARM: The alarm output is operated during an alarm operation or by the short key of our keyboard.
1-5 MIN(minute): The alarm output is operated during this setting time only by the function run of
the dome menu or the short key of our keyboard.
NOTE: This 1-5 MIN setting is not operated by an alarm.
There are 9 levels of priority. The function can be selected by Preset, Auto scan, Pattern or Tour and “0” is
the highest priority. Lower priority alarms won’t be serviced until the higher priority alarm is completed.
Equal priority alarms will be serviced repeatedly with the dwell time.
3.13 Dome Setup
• HOME FUNCTION SETUP
HOME FUNCTION : None/ Tour/ Pattern / Auto Scan / Preset
FUNCTION NUMBER : - - -
WAITING TIME : 10~240 Seconds
FUNCTION ENABLE : ON/ OFF
The Home function can be set so that the camera automatically goes to Preset, Tour, Pattern, Auto Scan after
the keyboard controller has been idle for a amount of time. For example, if the controller is idle for 120
seconds, the camera goes to preset 1.
Follow these steps to program the Home position:
1. Select Home Function by pushing the Joystick to the right or to the left to scroll through the None, Tour,
Pattern, Auto Scan or Preset functions.
2. Select Function Number and push the Joystick to the right or to the left. The recorded function number
will scroll.
3. Select WATING Time and push the Joystick to the right or to the left to select from 10 to 240 seconds.
4. Select Function Enable and turn to ON or OFF by pushing the Joystick to the right or to the left.
CONFIGURATION MENU
HOME FUNCTION SETUP
VIEW ANGLE SETUP
ORIGIN OFFSET
FACTORY DEFAULT
DOME RESET
OSD DISPLAY
SYSTEM SETUP
FUNCTION RUN
SYSTEM INFORMATION
EXIT
HOME FUNCTION SETUP
FUNCTION : NONE
NUMBER : ---
WATING TIME : 120 SEC
ENABLE : OFF
SAVE AND EXIT