Teledyne LeCroy WaveLink Differential Probe Series (8-13 GHz) - Manual (Page 34)

WaveLink Medium-Bandwidth (8-13 GHz) Differential Probe
Long Interconnect Extender
The long interconnect extender (provided with Dxx30-PT-KIT) is used to connect the probe to the
EZ-microtech positioner arm. Attach the probe by first removing the screws holding the top plate to
the V-shaped probe holder. Rest the long interconnect extender in the V-shaped groove, and fasten
the top plate to the holder, using the removed screws (as follows). Then, insert the Dxx30-PT onto
the long interconnect extender.
Positioner tip mounted to EZ probe positioner and long interconnect extender.
NOTE: Do not overtighten the screws. There is no fine adjust on the EZ probe. It is easy to exceed the
Z-Axis compliance rating of the PT. Use care when positioning the PT with the EZ probe.
Once the probe has been attached, loosen the knob on the EZ positioner arm and position the probe
close to the test point. Tighten the knob and use the joystick to fine position the probe.
Dxx30-PT-XYZ-Positioner
This positioner is a small, lightweight device that can be affixed to the printed circuit assembly using
the included adhesive pads. The black adhesive pads are for more permanent attachment, whereas
the white adhesive pads leave less residue when removed. The wide variety of short, long, swivel,
and right angle interconnect parts can be connected to the top assembly, which can then be moved
up and down along the Z-axis to increase or release pressure on the probe points. The bottom
assembly contains a tightening wheel which can be loosened to allow minor X-Y axis adjustments,
and then tightened to fix the exact probing position.
28 924234-00