TREND 963 User Guide - Manual (Page 77)

Using 963
963 User Guide TC200635 Issue 3 25/03/2008 77
If all the users in the ‘System Administrator’ workgroup are locked it will not be possible to log in as
anyone with enough authority to unlock user therefore you should go directly to step (2).
2. Click or on the Mode menu click Users to select the User Display.
3. Double-click the System Administrator workgroup.
4. Right-click the locked user and click Unlock User. The Password dialogue box is displayed.
If a database password has not been set up a warning message is displayed click OK to display the Set New
Password dialogue box and got step (7).
5. In the Password box enter the database password. When deciding on the password it is recommended that
the password be at least seven characters long, and contain a mixture upper and lower case characters, and
use some numeric characters.
6. Click OK. The Set New Password dialogue box is displayed.
7. In the Password box enter the new password.
8. In the Confirmation box enter the new password.
9. Click OK.
Note that the next time they log in, they will be forced to change their password to ensure that it is only known to
them.
3.17.2 Data
3.17.2.1 Archive Data
The historic data (graph data, recorded schematics and alarms) within the supervisor can be archived to an external
data source. The data can either be deleted from the 963’s database or kept for future reference. The archived graph
data can be played back using the Load recorded data option in the Graph Window. The archived schematic data
can be played back using the View recorded data option on the Data Recording menu.
To archive data:
1. Log in as described in the ‘Log In’ section of this manual.
Note that if running 963 Secure you must have system administrator access rights.
2. On the Database menu click Archive Data. The Archive Historic Data dialogue box is displayed.
3. Click Next>. The dialogue box changes.