Warner Electric FM Series Foot Mounted Load Cells AC10 Measuring System A-B-C30 - Manual (Page 47)

47 Warner Electric • 800-825-9050 P-2012-4
Series 30, Type B Shaft Diameter Code
Code 12 16 20 23
Inches 3/4 1.0 1-1/4 1-7/16
RH 1.00 1.13
Notes:
W1 unit shown here.
W2 unit is applied at the opposite end of the roll.
W1 unit clamps the shaft while W2 allows for
temperature expansion of the roll.
Both units have self-aligning feature.
4-Pin Connector
Mounting
**5/8-11
3.75
2.88
3.63
2.31 RH
2.44
1.56
1.63
1.06
1.82
3.13
.94
.25 DIA Hole Thru
**Warner Electric wall mounted tensioncells are located by a 5/8-11 bolt at the roll centerline and locating tab which
maintains rotational position of the tensioncell. (See Page 6.)
Note : Other shaft diameters are availible in special order.
Contact Warner Electric for other shaft diameter avalibility.
Table II-B