ZOLL X Series Monitor Defibrillator Rev H - Manual (Page 43)

Defibrillator Controls and Indicators
9650-001355-01 Rev. H X Series Operator’s Guide 2–3
Table 2-2. X Series Controls and Indicators
Control or Indicator Description
Display screen Shows therapeutic settings, physiological waveforms and other
information for each monitored parameter, messages, time, and quick
access key labels.
Quick access keys Seven buttons control different functions of the unit. Labels for the quick
access keys appear on the monitor display to the right of each key.
Auxiliary power LED Illuminated when the unit is plugged in to an auxiliary power adapter.
Battery charge LED Indicates battery status:
Steady yellow: Battery is charging.
Steady green: Battery is charged.
Alternating green and yellow: The charge state cannot be determined
or a battery charging fault has been
detected.
No light: Battery is not installed.
Visual alarm
indicators Red, yellow, and green lights located on the top of the unit that flash on
and off when the unit is powered up and are used to indicate a patient
alert, equipment alert, and data transfer.
Pacer button Displays pacer settings window to start/stop pacing activity or change
the rate, output, or mode settings.
ANALYZE button Displays in Manual mode only. Initiates ECG analysis to determine
whether or not a shockable rhythm is present.
ENERGY SELECT
buttons Two sets of up-down arrow buttons control the selection of defibrillator
energy; one set is located on the front panel and the other set is located
on the STERNUM paddle.
CHARGE Button Charges the defibrillator to the selected energy. In addition to the
CHARGE button on the front panel, there is one located on the APEX
paddle handle.
Shock Button The front panel Shock button is only active when using hands-free
therapy electrodes or internal defibrillation paddles without a discharge
button. The Shock button illuminates when the device is charged and
ready.
To discharge the defibrillator when using paddles (internal or external)
with discharge buttons, press and hold the SHOCK buttons on the
paddles.
NIBP button Starts/stops an NIBP measurement.
Snapshot button Records 24 seconds of numeric and waveform data.
PACER