SaltDogg WB200A - Manual (Page 13)

1
by Buyers
SET CONTROL
HANDLE TO "30"
ADJUST RESTRICTOR
SO IT IS FULLY OPEN
(HOPPER NOT SHOWN
FOR CLARITY)
Second jam nut must be
removed before mounting upper
linkage to linkage plate assem-
bly. After controls are set, it must
be re-mounted flush against
bracket and tightened with 1/2"
wrenches.
First jam nut must be
adjusted so it is flush
against the bracket
when the restrictor plate
is fully open and the
control handle is at "30".
18. Set the controls by first adjusting the restrictor plate
so it is fully open. Then remove the second jam nut from
the upper linkage and insert the upper linkage into the
small bracket of the linkage plate assembly. Set the
control handle to "30" and adjust the first jam nut so it is
flush against the small bracket. Now reattach the sec-
ond jam nut and tighten with 1/2" wrenches.