SaltDogg WB200A - Manual (Page 5)


by Buyers
2. Loosely assemble the axle components to the frame
A. Attach the Drive Gear(15) to the axle with a
m6x40 bolt
B. Position the Spinner Shaft Support(20) and orient it
as shown
C. Add one Shim Washer(21) as shown
D. Add the two stainless steel Locking Collars(24)
E. Add two plastic axle Bushings(22)
F. Insert the axle and components thru the frame holes
and add third Bushing to coast wheel side as shown.
3. Position the Spinner Assembly(5) into the Spinner
Shaft Support(20) and assemble the parts so that
the small gear fits into the drive gear. Using a Cotter
Pin(23), pin the Shim Washer against the Spinner Shaft
Support as shown.
4. Loosely mount the spinner shaft mounting plate
to the frame using the two m6x45 bolt that have flat
washers pre-mounted.
5
12
13
21
23
22
15
20
21
M6x45 WITH
M6 FLAT WASHERS (x2)
M6x40
M6x45
23
DRIVE WHEEL
MOUNTING HOLE
DRIVE GEAR
MOUNTING HOLE
22
14
17
24
M6x45
M6x40
RIB SIDE MUST
FACE AWAY FROM
LARGE GEAR
SHIM
WASHER
COTTER
PIN
M6x45
(WITH WASHERS)
MOUNT TO HOLES
IN FRAME
(with washers)