SaltDogg WB200A User Manual
Page 8
Advertising
by
Buyers
6. Position the spinner shaft straight and then loosely
assemble the Hopper Assembly(4) and the Deflector
Assembly(6) to the frame. The spinner shaft will go
through a hole in the bottom of the hopper assembly.
7. Verify that the spinner shaft is still straight and fully
tighten the hopper assembly to the frame.
4
6
M6x50 MACHINE SCREW
WITH FLAT WASHER (4x)
MAKE SURE REAR
SCREWS GO
THROUGH HOPPER
SUPPORT
BRACKETS(17)
17
17
SPINNER SHAFT
M6x50
Advertising
This manual is related to the following products: