SaltDogg WB200A User Manual
Page 6
by
Buyers
STAINLESS STEEL LOCKING COLLARS
MUST BE FASTENED WITH ALLEN
WRENCH (INCLUDED)
INSIDE PLASTIC BUSHINGS(22) MUST
BE FULLY SEATED AGAINST THE FRAME
ADD SHIM WASHERS BETWEEN WHEEL
AND PLASTIC AXLE BUSHING IF NEEDED
PLASTIC
BUSHING(22)
12
13
ONLY ONE PLASTIC
BUSHING ON THIS SIDE
DRIVE WHEEL(12) HAS A HOLE THROUGH
THE HUB USED TO MOUNT TO THE AXLE
WITH A M6x45 BOLT
MAKE SURE TIRE DOES NOT CONTACT FRAME
5. Mount the Drive Wheel(12) to the axle using an
m6x45 bolt. Mount the Coast Wheel(13) using shim
washers and a cotter pin. Tighten the entire axle
assembly as shown
A. Make sure the bushings inside the frame tubes
are fully seated against the frame
B. Using the included allen wrench, tighten the set
screws in the collars to lock them in place against
the bushings
C. The coast wheel side should have only a small gap
between the outside shim washer and the cotter pin
D. Add shim washers between wheel and Plastic Axle
Bushing if needed.
M6x45