SaltDogg WB200A - Manual (Page 9)


by Buyers
8. Recheck the axle spacing to make sure that the plas-
tic bushings and stainless steel collars are still in place
against the frame.
9. Tighten all frame bolts and recheck the spinner shaft
to make sure it is still straight and also check the posi-
tion of the bushings and collars.
(FRONT DEFLECTOR NOT SHOWN FOR CLARITY)
SPINNER SHAFT MUST BE
STRAIGHT (PERPENDICULAR
TO THE AXLE)
RECHECK SPACING
TIGHTEN THESE BOLTS
AFTER VERIFYING
SPINNER SHAFT IS
STRAIGHT AND AXLE
SPACING IS STILL INTACT
GEARS MUST
INTERFACE OR
"MESH"
10. Check that the axle rotates freely, the gears inter-
face well and then tighten the support bracket to the
frame.
11. Verify that the spinner shaft is straight, the axle
turns freely and that all hardware is tight.