AMX Metreau Entry Communicator with Display MET-ECOM-D - Manual (Page 38)

Using the Configuration Manager
32 Metreau Entry Communicators
Checking the Firmware Version
The firmware version is listed on the Summary of Device Settings page, in the Device Information
section at the top of the page.
Determining the IP settings of the Metreau Entry Communicator
1. Browse to the Summary of Device Settings page.
2. The IP settings are listed in the IP Settings section.
Rebooting the Device
1. Open the Summary of Device Settings page.
2. Click the Reboot button on the left bottom of the page.
Summary of Device Settings Page (Cont.)
IP Settings
IP The IP setting of the unit; either Static or Dynamic.
Host The hostname of the unit.
IP Address The IP address of the unit.
Subnet Mask The subnet mask associated with IP addressing
Gateway The IP gateway used by this unit.
MAC Address The MAC address of the unit.
NetLinx Settings
Status The connection status of the device.
System Number The NetLinx system number.
Device Number The ICSP device number of this unit.
Master IP The IP address of the NetLinx master connected to the device.
Master Port Port number for the NetLinx master connected to the device.
Friendly Name The friendly name of the device as it appears in the NetLinx master connection tree.
System Resources
File System Amount of memory available to the file system.
RAM Available RAM on the device.
It is necessary to reboot the device in order to apply changes to several
communication options, including Setting the IP and DNS Addresses, and setting the
ICSP connection and encryption status for the NetLinx Master (see page 35).