Proface FP3900 - 19 Flat Panel" - Manual (Page 11)

11
„ Serial Interface
Pin Assignments and Signal Names for Serial Interface
*1
The CD, DTR, and DSR are connected together inside of the FP.
Connector ..................... Dsub 9 pin female
Connector set screw ..... Inch type (#4-40UNC)
Cable............................. SIO cable for FP manufactured by Pro-face.
(FP61V-IS00-O)
Concerning Signal Names
Signal names used for the serial interface on FP units are designed to match the
pin order used on most PC serial interfaces, so that a straight cable can be used
to connect the two. Therefore, connect each pin’s signal to the same signal name
on the PC side.
For example, pin #2 ‘RD’ should be connected to the ‘RD’ input terminal on the
PC’s connector.
Refer to the FP3000 Series User Manual’s section “Cable Diagrams” for each
signal’s direction.
„ USB Interface (Type-B connector : Up-Stream Port)
Pin Assignments and Signal Names for USB Interface
Cable............................. USB cable manufactured by Pro-face.
(FP-US00)
RS-232C Serial Interface
Baud rate : 9600 bps
Data length : 8 bits
Parity : None
Stop bit : 1
Flow Control: None
Pin No. Signal Name Condition Pin Location
1 CD Carrier Detect
*1
2 RD Receive Data (FP->Host)
3 SD Send Data (FP<-Host)
4 DTR Data Terminal Ready
*1
5 GND Ground
6 DSR Data Set Ready
*1
7 RS Request to Send (FP<-Host)
8 CS Clear to Send (FP->Host)
9 NC (Used internally)
Pin No. Signal Name Condition Pin Location
1 USB1-5V +5VIN
2 USBD1(-) USB data(-)
3 USBD1(+) USB data(+)
4 GND Ground
• If a cable other than the specified USB cable is used, product
performance cannot be guaranteed due to the possibility of
noise interfering with the FP unit’s operation.
6
9
1
5
4 3
2
1