Proface FP3900 - 19 Flat Panel" - Manual (Page 16)

16
‹Power cable connecting
(1) Make sure that the power cable has no power distribution.
(2) Remove the power connector from the unit.
(3) There are three screws located in the center of the connecter. Make them
loosen.
(4) Peel some of the outside of shield part, twist core wires, and insert the wire
into each cable joint.
(5) Fix all of them with screws.
(6) Install the connector in the FP. With both sides of the installation screws of
the connector, fix them firmly.
.
„ USB Cable Clamp Attachment Procedure
‹Installation to USB cable
(1) Insert the USB cable into the USB connector.
(2) Tighten the clamp until the cable is secured in place and insert the convex of
cable clamp into the USB fixing hole to fix both as shown in the following
figure.
‹USB Cable Clamp Removal Feature
(1) Push up the cable clamp’s stopper with a standard flat-blade screwdriver
until the cable clamp is unlocked.
(2) Disconnect the USB cable.
• Use a minus driver when fixing terminal screws. The
necessary torque is 0.5~0.6N•m [ 5~7 lb•in ].
• Cable joints are not allowed to solder.
7 Using the USB Cable Clamp
• If the stopper will not move, press on <A> (shown in the
figure) to free the clamp from the clamp holder.
+
-
FG
USB cable
USB Cable Clamp
Stopper
<A>
USB fixing hole