Yokogawa Removable Chassis DX1000N - Manual (Page 107)

App-10
IM 04L41B01-04E
Appendix 2 Viewing Screens Created in DAQStudio
This is an example of how to view a screen created in DAQStudio on a DX recorder.
Procedure
When receiving screen data from the DX recorder, the Channel/alarm list page is
displayed in the work area.
If the DX includes the /AS1 option, set up the DX in advance as follows. (In the example
of setting up the DX below, the user ID is not set.)
DX main unit (with /AS1 option) settings
1. Press MENU (to switch to setting mode), hold down FUNC for 3 s (to switch to
basic setting mode), and select the Environment tab > Security > Communication,
and set Login.
2. Select the Menu tab > User registration > Admin settings > Mode, set [Key+Comm],
enter the user name, and return to the operation screen.
If a password is set, this concludes the setup. If no password set, perform the following
additional steps.
3. Press FUNC, select Admin1, then press DISP/ENTER.
4. Skip the user ID and select ENT.
5. Enter Admin1 for the password, then select ENT.
6. Enter a new password (between 6 and 20 alphanumeric characters, no spaces
allowed), then select ENT.
7. Reenter the new password and select ENT.
Operation of DAQStudio
1. Open data that was created and saved in DAQStudio. When you open such data,
if there are components to which bitmaps are assigned, be sure you save the
bitmap files in the same location as the screen data.
2. On the menu bar, click Communication > Send.
The send dialog box appears.
3. Check that the screen version and DX recorder version match.
If the DX recorder version is earlier than the DAQStudio screen version, some
components may not display.
4. Enter the IP address and host name, and the user name, user ID, and password
set on the DX recorder.
If a user name is not set on the DX recorder you are sending to, enter [admin].
5. Click the [Send] button.
The screen sent to the DX recorder is displayed.