Yokogawa Removable Chassis DX1000N - Manual (Page 38)

2-8
IM 04L41B01-04E
Attribute Description Default value
Tag font
(Displayed only
when Tag No. is
set to On.)
Set the character size of tag comment.
(Available font types are same as those for channel font.)
Note that this field will not be available when the
direction is set to [Horizon].
Font 6
Digital font Set the character size of digital value. You can select
[Font 5], [Font 6], [Font 8], [Font 12], [Font 16], or [Font
32]. Note that this field will not be available when the
direction is set to [Horizon].
Font 6(DX1000)
Font 8(DX2000)
Unit font Set the character size of unit font.
(Available font types are same as those for channel font.)
Note that this field will not be available when the unit
display is set to [Off] or the direction is set to [Horizon].
Font 5
Span font Set the character size of span value.
(Available font types are same as those for channel font.)
Note that this field will not be available when [Span
display] field is set to [Off].
Font 5
Bar color Set the color of a bar. You can select either [CHANNEL]
or [Green]. If you select [Green] at this setting, the bar
will be displayed in a color of the alarm when the alarm
goes off.
CHANNEL
Base position Set the base position of a bar graph. You can select
[SET], [Normal], [Center], [Lower], or [Upper].
[SET]
Direction Set the direction of a bar graph. You can select either
[Vertical] or [Horizon]. The default value will depend on
the aspect ratio of component size drawn.
Depend on the
aspect ratio of
component size
Length ≥ Width:
Vertical
Length < Width:
Horizon
Alarm display You can choose to show or hide the alarm display
mark by setting [On] or [Off] at this field. From left, it is
level 1, 2, 3, and 4 respectively. When alarm is set to
[Off], it is displayed in lime. When alarm is [On], it will
be displayed in a color configured for each level (red,
orange, yellow, or pink).
Note that this field will not be available when the
direction is set to [Horizon].
On
Alarm mark
display
You can choose to show or hide the alarm set-point
mark by setting [On] or [Off] at this field.
On
Digital display You can choose to show or hide the digital value by
setting [On] or [Off].
On
Unit display You can choose to show or hide the unit display by
setting [On] or [Off].
On
Span display You can choose to show or hide the span display by
setting [On] or [Off].
On
2 Line display You can choose to display the tag (tag comment) in
two lines by setting [On] or [Off].
(The character strings for channel font will be displayed
in two lines. When the Tag No. is set to On, the
character strings for tag font will be displayed in two
lines.)
Off
Frame Set the frame of a component.
See page 2-2.
Raised
Depend ID Set the ID number of the component on which this
component is dependent. See Section 2.2.
None
Visible You can choose to show or hide this component by
setting [On] or [Off]. See Section 2.2.
On
Group control Set the control status of group displayed.
See Section 1.11 and Section 2.2.
None
Gr.Ctrl order Set the control order of group displayed.
See Section 1.11 and Section 2.2
1
Sync act See Section 2.2
2.4 Attributes of Bar Graph Components