Brocade TurboIron 24X Series Hardware Installation Guide - Manual (Page 14)

4 Brocade TurboIron 24X Series Hardware Installation Guide
53-1002981-01
Hardware features
1
Part# : PLRXPLSCS4371 Serial#: xxxxxxxxx
Port 15: Type : 10G XG-SR(SFP+)
Vendor: Brocade Version: 1
Part# : PLRXPLSCS4371 Serial#: xxxxxxxxx
Port 16: Type : 10G XG-SR(SFP+)
Vendor: Brocade Version: 1
Part# : PLRXPLSCS4371 Serial#: xxxxxxxxx
Port 17: Type : EMPTY
Port 18: Type : EMPTY
Port 19: Type : 10G XG-SR(SFP+)
Vendor: Brocade Version: 1
Part# : PLRXPLSCS4371 Serial#: xxxxxxxxx
Port 20: Type : 10G XG-SR(SFP+)
Vendor: Brocade Version: 1
Part# : PLRXPLSCS4371 Serial#: xxxxxxxxx
Port 21: Type : EMPTY
Port 22: Type : EMPTY
Port 23: Type : EMPTY
Port 24: Type : EMPTY
Port 25: Type : 1G M-C (Gig-Copper)
Port 26: Type : 1G M-C (Gig-Copper)
Port 27: Type : 1G M-C (Gig-Copper)
Port 28: Type : 1G M-C (Gig-Copper)
10 Gbps ports
Ports 1 - 24 support 1-GbE SFP transceivers and 10-GbE SFP and SFP+ transceivers listed in
Table 1 . Figure 3 shows ports 1 - 24.
FIGURE 3 24 10-GbE ports
Four 10/100/1000 Mbps ports
The ports 25~28 are 10/100/1000 copper ports that use auto-sensing and auto-negotiating to
determine the speed (10 Mbps, 100 Mbps, or 1000 Mbps) and mode (full-duplex or half-duplex) of
the port at the other end of the link, and adjust port speed accordingly.
10/100/1000 ports on the TurboIron 24X support RJ-45 copper connectors. The output of the
show media command displays C next to the ports that have copper connectors installed.
Gigabit copper ports on the TurboIron 24X support auto MDI or MDIX detection. For more
information about this feature, refer to "Configuring MDI/MDIX" in the TurboIron Configuration
Guide.
10GbE SFP+ transceiver
TurboIron 24X support a 10GbE SFP+ transceiver specifically for ports 1-24. LEDs on the module
faceplates indicate operational status:
1 10-GbE Ports
A
1