Brocade TurboIron 24X Series Hardware Installation Guide - Manual (Page 52)

42 Brocade TurboIron 24X Series Hardware Installation Guide
53-1002981-01
Replacing a power supply
5
Removing an AC power supply
Follow the steps to remove an AC power supply.
1. Unplug the power cord from the power source.
2. Disconnect the power cord from the power supply.
3. Loosen the two captive power supply locking screws located on the sides of the power supply.
FIGURE 15 Releasing the power supply
4. Hold the handle on the front panel of the power supply and pull outward. This will disconnect
the power supply from the backplane.
5. Continue to pull the power supply until it is removed from the device.
FIGURE 16 Removing the power supply
6. Place the power supply in an anti-static bag for storage.