Brocade TurboIron 24X Series Hardware Installation Guide User Manual
Page 27
Brocade TurboIron 24X Series Hardware Installation Guide
17
53-1002981-01
Installing the device
2
Follow the steps to install the rack mount brackets and mount the device in a rack.
1. Remove the rack mount kit from the shipping carton. The kit contains two mounting brackets.
2. Place the Network switch on a hard flat surface with the front panel facing you.
3. Attach a rack-mount bracket to one side of the Network switch with the supplied screws. Then
attach the other bracket to the other side.
DANGER
Make sure you use the screws supplied with the mounting brackets. Using the wrong screws
could damage the TurboIron 24X and would invalidate your warranty.
shows how to attach the short mounting brackets.
FIGURE 5
Attaching the short mounting brackets
Mount the device in the rack as illustrated in
.